The TF03A series uses a stainless steel band to secure PEX tubing to compatible insert fittings. A PEX cinch tool closes the ear, drawing the band around the tubing and compressing it against the fitting. Select the part number by nominal PEX tubing size and verify compatibility with the tubing, fitting, and tool.
Figure 1 Installed Rotational Envelope Diameter RD (Generic Illustration)
Figure 1 illustrates the installed envelope of a single-ear clamp. Refer to the applicable part drawing for TF03A installation dimensions.
| Part No. | Nominal Tube Size(in.) | Clamp Size Range(mm) | Ear Width(mm) |
| TF03A0001 | 3/8 | 10.8–13.3 | 8 |
| TF03A0002 | 1/2 | 15.0–17.5 | 10 |
| TF03A0003 | 5/8 | 17.8–20.8 | 10 |
| TF03A0004 | 3/4 | 20.1–23.3 | 10 |
| TF03A0005 | 1 | 25.4–29.6 | 10 |
See the part drawing for the measurement condition, tolerances and material grade.
Preparation. Check jaw condition and tool calibration as specified by the tool manufacturer. Cut the tubing square with a tubing cutter and check the cut end for burrs, cracks or visible deformation.
Positioning. Slide the clamp onto the tubing, seat the fitting to the specified insertion depth, then move the clamp over the designated clamping zone. Follow the fitting instructions for clamp position and setback from the tube end.
Closure. Center the jaws of a compatible PEX cinch tool on the ear and complete the specified closing cycle. With a ratcheting tool, continue until the mechanism releases as designed. For powered tooling, use the validated settings for the part number and jaw head.
Acceptance. Check clamp position, fully closed ear geometry and the tubing surface. Verify closure against the connection system criteria and perform the specified pressure or leak test on the assembly. Follow the approved rework procedure if the joint fails inspection.
For projects specifying ASTM F2098, verify the clamp requirements against the specified edition and check the applicable tubing and insert fitting specifications. Confirm potable water suitability, standards conformity and certification scope using documentation that covers the specific part number and connection system.
For a quote, specify the TF03A part number, nominal PEX tubing size, tubing and fitting models, and quantity. For a compatibility review, include a fitting drawing or sample and identify the intended tool and jaw head.
You can get a price or send us any questions to get any information you would like to know, and we will reply to you as soon as possible.