The standard rubber-lined P-clip secures tubes, hoses, cables, and wiring harnesses to a vehicle body, chassis, or equipment bracket. The metal band provides support, while the rubber lining separates the retained component from the band to help reduce vibration-induced chafing and noise.
The metal band wraps around the retained component. The mounting tabs overlap and are secured to the bracket through their mounting holes. The liner cushions contact along the inside of the band. Check the mounting hole, liner profile, and tab orientation against the part drawing.
Candidate applications include supporting and locating automotive wiring harnesses, protective conduits, hoses, and tubing along their routes. Select the band material and finish for the operating environment. Verify liner compound, hardness, service temperature, and compatibility with oils or cleaning agents that may contact it. Lay out support points to suit routing, bend radius, and clearance.
Measure the outside diameter at the mounting location. Include any sleeve or corrugated conduit when measuring a harness and check its largest cross-sectional dimension. Verify the effective lined inside diameter, band width, mounting hole, fastener, and bracket seating surface against the part drawing. Trial-fit the clip to check retention and liner compression.
Seat the liner evenly around the retained component and align the tabs with the bracket hole. Use the fastener specified on the assembly drawing and tighten to the specified torque. Inspect tab seating, liner position, and any deformation of the retained component. Verify clearance from nearby parts during operation.
For locations subject to vibration or relative movement, check line migration, liner wear, and fastener retention as required by the application. After trial assembly, check flexible hoses and harnesses for flattening, sheath damage, or excessive bending at the support point.
Provide the Towin part number or specify the line outside diameter and tolerance, band width, mounting hole diameter, band and liner material requirements, and quantity. For new applications, include the bracket drawing and specify temperature, fluid exposure, and vibration conditions.
You can get a price or send us any questions to get any information you would like to know, and we will reply to you as soon as possible.