Search

Unitary Clamp

This European-type heavy-duty hose clamp uses a single bolt assembly to draw a wide band tight around a hose-to-fitting joint. The fastener is operated from one location. Select the clamp based on assembled hose outside diameter, usable clamping width, and clearance at the closure.

Descriptions

Construction and Load Transfer

The tightening bolt transfers load through the load-bearing components at the band ends, drawing the band tight against the hose. Solid-trunnion designs use solid load-bearing pins. Where fitted, a bridge spans the closure gap and supports the hose beneath it. Refer to the part drawing for the exact construction.

 

Applications and Materials

Candidate applications include coolant hose joints on commercial vehicles and construction machinery, as well as industrial equipment hose connections. Review hose reinforcement, hardness, wall thickness, and fitting geometry. Validate the joint under the specified fluid, temperature, pressure, and vibration conditions. Confirm the materials and finishes of the band, bolt, trunnions, and bridge by part number.

 

Clamping Range and Clearance

Seat the hose to the specified depth and measure the assembled outside diameter at the clamping location. Check both tolerance limits against one part number’s clamping range. Ensure the entire band fits on the designated clamping land. During trial assembly, verify clearance around the bolt head, trunnions, and protruding bolt end, and check that the socket can engage fully.

 

Installation and Torque Control

Seat the band squarely on the specified clamping land and position it relative to the fitting bead as shown on the drawing. Check closure alignment and bridge seating, where applicable, then tighten with a matching socket to the approved torque. Recheck the torque setting if the fastener specification, finish, or lubrication condition changes.

 

Inspection and Joint Validation

Check band alignment, closure seating, thread engagement, and hose condition. Inspect for cuts or excessive extrusion. Before production, trial-fit assemblies at both outside-diameter tolerance limits and verify sealing, pull-off resistance, or performance after thermal cycling as required.

 

Ordering Information

Provide the Towin part number or specify the assembled outside-diameter limits, band width, material requirements, available closure clearance, and quantity. For new applications, include hose and fitting drawings and the service conditions.

Menu

Get a Quick Quote

You can get a price or send us any questions to get any information you would like to know, and we will reply to you as soon as possible.

Update cookies preferences